Small mini Laboratory Jig equipment

Small mini Laboratory Jig equipment

Click here to get Trimming lace and parts' price.

Recommendation Index:  

  See more pictures

  Brochure Download (PDF)

  • Small mini Laboratory Jig equipment Application:

    Diaphragm Jig is applied to gravity concentration, which makes layered separations of ore grain mixture using difference in mineral weight based on variation of settling speed for the different specific gravity of ores in medium. The product is made by the only manufacturer designated by the former Ministry of Geology and Mineral Resources, in compliance with the industrial standards.


    Small mini Laboratory Jig equipment Structure & Working Principle:

     The top of the diaphragm jig is rectangular and bottom of it is pyramid-shaped washing trough. These washing troughs are linked together and installed on frame to become one. There are two jigging area, and diaphragm area in each trough. The two jigging area are separated by a division plate that doesn’t reach the bottom. Each trough serves the same one transmission device and is equipped with water valve as well as water pipe. The jigging process in the upper side of the jigging area causes the agitation of water through the reciprocating motion of the diaphragm, so as to realize mineral separation. When the diaphragm moves downward, it supply supplement water under the sieve plate. The supplement water is adjusted through the water valve. The water valve and diaphragm operate synchronously. When the diaphragm moves upward, the water valve is opened. Therefore, the function of descending water current in the jig is reduced.

    The trough is cast by gray pig iron. The diaphragm is fixed on the horizontal iron washer of tank which is well sealed. The diaphragms are connected through the eccentric links and as well as diaphragm and lever. They do reciprocating motion. Therefore, corresponding agitation is caused in the working chamber. The lever is then connected with the eccentric link covered on the shaft. The shaft is driven by motor through V-belt and belt pulley.   Due to different heights of each working chamber, the raw ores are fed into the jigging room after passing the feeding trough. They are discharged out after driven by water due to different specific gravities of ores. The ores sinking into the lower layers have large specific gravities. They pass the stop valve and rubber hose (the length of rubber hose depends on the actual service conditions) and then enter the ore discharging bottle. The ores at the upper layer with small specific gravity flow out along the overflow channel.

  • Small mini Laboratory Jig equipment technical specifications:

     Model  Unit XCT100×150 XCT200×300
     Length mm 150 300
     Width mm 100 200
     Jig chamber set 2 2
    jig Area m2 0.03 0.06
     Stroke mm 20 32
     Feed size mm 3 6
    Times of stroke 1/min 420 346
     Capacity kg/h 20-70 700
    Water comsumption L/S 0.117 0.117
    Water comsumption L/S 0.1 0.1
    Power kw 0.4 0.75
    Overall dimensions mm 752×520×1312 1110×520×1312
    Weight kg 150 175

  • Name:         


    E-mail:         *


    Mobile No.: